A Bluetooth RC car is a 2WD chassis, an L298N driver and an HC-05 that hands your phone’s button presses to an Arduino. Every app button sends one ASCII character, and the sketch is a switch-case that turns each character into an H-bridge state.
Author Archives: Amir Hakim
A complete 2WD obstacle-avoiding robot car with an Arduino Uno, L298N and HC-SR04 — from peeling the chassis film and soldering the motor tabs to the battery maths that decides whether it rolls or crawls, plus the full runnable sketch with per-motor speed trim.
An HC-SR04 measures hand distance, the Uno checks one threshold, and an SG90 servo lifts the lid — with the power split that keeps it steady.
The one wiring mistake that silently disables your TP4056’s protection, plus charge-current resistors, LED meanings, the real 4.2V and 2.4V thresholds, and honest current maths for boosting a single 18650 to 5V.
Just bought a cheap multimeter but the symbols on the dial mean nothing to you? There are only three modes you really need for Arduino work — DC voltage, continuity and Ohm. This guide has a dial symbol table, a range-picking table for every kind of measurement, and the reason the 10A jack can destroy your meter.
Three parts — an LM393 rain sensor, an Arduino UNO and an SG90 servo winch — and your model clothesline pulls the laundry in the moment rain is detected.
A 180° servo moves to the angle you command and holds it; a 360° (continuous) servo cannot hold an angle at all — its write() value controls speed and direction instead. A 270° servo is simply a positional servo with a wider sweep. All three look identical from the outside, so below is a 30-second […]
To solder header pins, push the header’s long side into a breadboard, sit the module on top, then touch a 350 °C iron to both the pad and the pin for 1–2 seconds while feeding solder into the joint — about 3 seconds per joint. A good joint looks like a shiny little volcano, and 15 […]
Your LM2596 buck converter ships at a random output — often 9V or 12V — and that is normal, not a defect. To set it to 5V, connect a 7–12V input to IN+/IN−, probe OUT+ and OUT− with a multimeter set to DC volts (the 20V range on manual meters), and slowly turn the trimmer […]
On the L298N, IN1 and IN2 choose direction and analogWrite() on ENA sets the speed. The catch: ENA ships with a jumper cap fitted, so nothing changes until you pull it off.











