Two parts share the word “vibration” and do opposite jobs. Which one your project needs, how to drive a 3V-6V coin motor from an Arduino without frying a pin, and how to turn the SW-18010P’s millisecond pulses into one clean knock event.
Author Archives: Amir Hakim
A rocker or a toggle stays where you left it; a push button only acts while your finger is on it. How to read 2-pin, 3-pin and SPST markings, size the panel cut-out before you drill, and check the rating moulded on the body.
Unplugging a finished project from the laptop means picking a wall supply, and the two numbers on the label do very different jobs. Why the voltage must match what the board’s regulator expects, why a 5 A rating is a ceiling and not a force, and how to avoid the 5.5×2.1 versus 5.5×2.5 barrel trap.
A water level relay controller fills a tank by itself: two conductive probes set the restart and shut-off heights, and the relay switches the pump — no microcontroller and no code.
Four fresh alkaline AA cells make about 6.4 V; four charged NiMH make 5.6 V and settle at 4.8 V. That gap decides whether your servo, your 5 V rail or an Arduino’s barrel jack works — with the pack arithmetic, the capacity and self-discharge truth, and when to stop fighting AA cells.
A donut board pre-connects nothing — every pad is an island. How the double-sided plated pad grid works, how to build the ground and power rails a breadboard used to give you for free, the three honest ways to join two pads, and how to plan the layout before the iron is hot.
An ultrasonic mist maker is a piezo-driven plate full of micro-holes, and the water it atomises is also its only coolant. Here is how the plate and its 108 kHz driver work, why a dry plate dies permanently, and how to switch the module’s own 5 V supply from an Arduino with a relay and a water-level cut-off instead of driving it from a pin.
Li-ion 18650, LiPo pouch and LiFePO4 compared: real voltages, real sizes, the actual hazards, and which one belongs in your Arduino or ESP32 project.
An Arduino Uno’s 5V pin holds up about one SG90, not four. Here is the current budget with the numbers derived, how to run four servos off a 4xAA pack with a common ground, and the incremental joystick sketch that makes the arm hold its pose when you let the stick go.
Your multimeter has no farad range, and it can still tell you whether a capacitor is good, open, shorted or leaky. The charge-and-discharge check, the safe way to drain one first, and the bulge and leak signs that need no test at all.











